Areca ARC-1882LP Uživatelský manuál stáhnout pdf (Strana 38)

HARDWARE INSTALLATION

McRAID Storage Manager

Before launching the rmware-embedded web server, McRAID

storage manager through the PCIe bus, you need rst to install the

ArcHttp proxy server on your server system. If you need additional

information about installation and start-up of this function, see the

McRAID Storage Manager section in Chapter 6.

SNMP Manager Console Integration

There are two ways to transport SNMP data on the 6Gb/s SAS RAID

controller:In-Band PCIe host bus interface or Out-of-Band built-

in LAN interface. Enter the “SNMP Tarp IP Address“ option on the

rmware-embedded SNMP conguration function for user to select

the SNMP data agent-side communication from the Out-of-Band

built-in LAN interface. To use In-Band PCIe host bus interface, keep

blank on the “SNMP Tarp IP Address“ option.

• Out of Band-Using LAN Port Interface

Out-of-band interface refers to transport SNMP data of 6Gb/s

SAS controllers from a remote station connected to the control-

ler through a network cable. Before launching the SNMP manager

on clinet, you need rst to enable the rmware-embedded SNMP

agent function and no additional agent software inquired on

your server system. If you need additional information about

installation and start-up this function, see the section 6.8.4 SNMP

Conguration.

• In-Band-Using PCIe Host Bus Interface

In-band interface refers to management of the SNMP data of

6Gb/s SAS controllers from a PCIe host bus. In-band interface is

simpler than out-of-band interface for it requires less hardware

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 196 197

Žádné komentáře

Areca ARC-1882LP Uživatelský manuál Strana 38